Team Fission Combat Robotics

We took a trip to York at the weekend to compete in our first official event as a full competitor. Upon arriving at the venue, we realised we would have had no chance of finding it if we didn't have Thomas Yau there to point us into the right building! We were among the first to arrive, so we had time to set up and grab some space before the rest of the competitors, and spectators, arrived. With a total of 31 antweights and 12 beetleweights, there was barely enough space for everyone to work on their robots. The competition format was a sort of group stage format so everyone got 4 guaranteed fights but could have more in the form of playoffs. Fight 1: vs Baby Dead Bod This was an absolutely terrifying first fight to have, Baby Dead Bod is an immensely powerful horizontal spinner so I was not happy to face it this early on. That was quick! A single hit on the weapon was all it took to flex the weapon into the pulley, sending it flying and completely shearing the motor shaft. This wa

 Updates! Since BBB Brawl, a lot of work has gone into this robot. This includes the purchase of an 8mm thick bar of mild steel, which was cut, by hand, into a spare weapon for testing and as a backup. The offcuts from this piece were cut and drilled into two sets of long, 8mm thick forks. The 3D printing was successfully done in high-infill green TPU, giving us the fork mounts, four wedgelets to counter drums, and the sharp edge protection for the Hardox weapons and forks, which have not yet arrived. It is unlikely that the Hardox will arrive before we leave for RoboDojo tomorrow, meaning we will have to use the mild steel weapon at the event. The preexisting HDPE wedgelets have been given an angle to save some weight and will remain as the anti-horizontal setup. Following the wheels taking damage at Bristol, one of them has been replaced as it was slipping quite a lot and all have been given a few coats of rubber cement to improve traction. They have also been covered by wheel guards